Megsu Arc Wooden Hammock Stand – Dimensions & Assembly Instructions

Product Specifications & Dimensions

The Megsu Arc Wooden Hammock Stand features a dramatic crescent silhouette steam-bent from layered solid European Larch hardwood. Treated with an eco-friendly outdoor waterproof polyurethane glaze, it withstands sun and rain while elevating any patio or garden.

Hardware & Tools Checklist

• 2x Main curved beam halves
• 2x Cross-leg stabilizer bases with rubber boots
• 1x Center steel joining plate with weather-resistant powder coating
• 4x M10 Heavy galvanized through-bolts, locking nuts & oversized washers
• 2x Heavy-duty stainless steel carabiners
• 2x 18-inch Hanging chains with link adjusters
• 2x Open-end assembly wrenches (17mm) included

4-Step Assembly Manual

Step 1: Connect Main Arc Beams

1. Align the two curved beam halves at the center joint over the heavy galvanized steel splice bracket.
2. Insert the M10 through-bolts from the top side.
3. Slide washers and lock nuts onto the bottom and tighten securely with the included wrenches.

Step 2: Mount Stabilizer Cross Legs

1. Position the two wide stabilizer cross-legs perpendicular to the main beam ends.
2. Secure the heavy angled lag bolts through the pre-drilled pilot holes.
3. Verify that the rubber feet sit flat on your patio or grass.

Step 3: Attach Suspension Hardware

1. Fasten the stainless steel eye-bolts through the pre-drilled holes at the very top of each curved tip.
2. Connect the carabiners and 18-inch suspension chains.

Step 4: Hang and Test Your Hammock

1. Hook your hammock ends to the chains using the carabiners.
2. Adjust chain links until the lowest point of the hammock hangs approximately 18–24 inches above the ground when unloaded.
3. Gradually apply weight before fully relaxing.